Throughbolts RSPT

Data Sheet 83

Specification Data

two lines intersect (interpolate as required).

Multiply this factor by the DESIGN

RESISTANCE or RECOMMENDED LOAD

quoted in the table. On the occasion that

multiple close edge and/or spacing

distances occur, the appropriate reduction

factors must be applied.

appropriate reduction factor/s from the

tables below must be applied to the

DESIGN RESISTANCE or RECOMMENDED

LOAD. Choose the required bolt diameter

across the top of the appropriate table and

read down the left hand column until

actual edge or spacing distance is found.

Read off the reduction factor where the

Reduction Factors - Edge and Spacing

Distances for Rawl® R-SPT

The full characteristic edge and spacing

distances shown in the table above are the

minimum allowable for the quoted DESIGN

RESISTANCE or RECOMMENDED LOAD,

depending on your design method. Where

these dimensions are not achievable, the

Metal Self Drive Plasterboard Fixings

DESCRIPTION

No drill required-simply pierce

paper skin and screw home.

Can be used in single and

double thickness plasterboard.

Ideal for use with either a

power or standard Pozi Drive

screwdriver.

Must only be used with screws

provided.

Suitable for use in:

Plasterboard.

Features

1. Flange prevents accidental

push through in

plasterboard.

2. Short length ideally suited