Data Sheet 95

Location Plates

Location Spacers

The location plate is an essential part of a

BeamClamp assembly. It provides support for the

fixings to react against and clamp onto the

steelwork flange. The hole centres of the location

plate are designed to suit the application and

ensure that the fixings are correctly positioned onto

the flange. BeamClamp division will design the

location plate to suit your application and

guarantee the load of the assembly. Each plate

manufactured by BeamClamp division will be

stamped to identify it. The fixings can be used with

location plates not manufactured by BeamClamp

division, however, in this case, we can only

guarantee the fixings and not the plate. Please

contact RSR BeamClamp division to discuss your

application ,

Manufactured from Mild steel grade S275

Hot Dip Galvanised as standard

5 to 1 Factor of Safety

Location spacers are two location plates joined together with a gap to allow for spaces between steelwork.

The plates can be welded at different angles to allow for sloping steelwork, such as, roof rafters.

Other variations can be manufactured to suit special applications.

Grating Clip

¦ Installation from one side only

¦ Fits 30mm to 41mm load bar centres

¦ Fits upto 50mm deep load bars as standard

¦ Slotted body for adjustment towards steelwork

¦ Cost effective

The Grating clip is a cost effective method of fixing

down open floor grating to steelwork without the

need to drill or weld. It can be installed with a flat

head screw driver from the top side of the grating

without access to the underneath required. It can

be easily removed to allow the grating to be taken

up for maintenance or re-positioning. The standard

clip can accommodate between 30mm to 41mm

load bar centres and to a depth of 50mm

Please contact RSR BeamClamp division if your

application is not within the above specifications,

we can modify the clip to suit most variations.

The pressed steel body has a slot down its length

to allow the body to be adjusted towards the

steelwork should the transverse bars fall in an

awkward position in relation to the steelwork

flange. This ensures that the body of the clip

always provides a good clamping surface

underneath the steelwork to improve the clamping

force and provide a good connection.