Flange Clamps

Data Sheet 36

Full Lindapter catalogue available on request

Step 1 Slide FL onto beam flange and tighten setscrew to recommended torque. To avoid over tightening, a rough guide to achieve the correct torque is to tighten the setscrew with thumb and forefinger and then apply a further quarter turn (90°) with a spanner.

Step 2 Tighten the locknut to the recommended torque.

The Lindapter FL Series of flange clamps is the simplest, quickest and most cost-effective method of suspending building services from steel beams. Suitable for use with parallel or tapered flange beams, the FL can be supplied with the back hole drilled to accept a plain rod or tapped to accept a threaded rod. Four different sizes are available to suit various applications - if in doubt which size to use, please contact Lindapter. The FL uses a grade 8.8 cup point setscrew to provide maximum bite into steelwork and maximum load performance.

Wedge Nuts (Vee Nut)

The Lindapter V Nut fits into the slots of 'V' profile composite floor decking, such as

HoloRib, and is available with a threaded hole tapped M4, M5, M6, M8 or M10. The VN is suitable for decking with a 15° tapered slot.